![]() In their datasheet ( ) mentions the V1.0 needs config, and v1.2 is UART mode, but further research brings it’s only UART compatible with the Fysetc F6 board… bummer! The “UART This! Instructable” and “Teachin Tech TMC2208 guide” tell to do some soldering on the 2208’s, use jumpercables with 1K resistors, plug it into AUX2 pins and tell the firmware what those pins need to do, but so far, I have not found AUX2 or any adjustable pins. Setting up for UART doesn’t work, probably because I have a Fysetc TMC2208 v1.2. While installing and testing, I’m running in some problems. I already have a set of TMC2208, so (I thought) am good to go with only the SKR1.3 board. What an absolute lovely tutorial, so I also wanted to give it a try. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |